5/21/2019 0 Comments Reprogramming Bmw Key FobDec 10, 2018 - Programming the keyless entry on your BMW key fob is a simple procedure, one that most drivers in and around Syosset should find easy to do. To do this, simply make a selection of the desired files in the Finder, right-click them, and then choose the Open option so they are all opened in the same Preview window. Convert pdf to png mac. Note that the images are shown in a list next to the displayed one. • Ignition switch to 'run' position, try to start and let key return to 'run' position • Approx ten minutes security light will go off • Turn key 'off' and wait 5 seconds • Repeat 2 more times for a total of 3 relearns. • Turn key off, then start it Step 2 - FORD KEY PADS • Enter permanent factory code • Press the 1/2 button within 5 seconds to enter programming mode • Within 5 seconds enter new code, doors will lock, unlock to verify code, this erases previous codes. Remotes will also need to be programmed. Step 3 - FORD KEY PADS/REMOTES • Insert key, turn ignition off-to-on eight times in succession, ending with key in on position doors will lock, unlock to verify in programming mode • Press any button on new remote, doors will lock, unlock to verify • Do the previous step with the second remote, doors will lock unlock to verify. • Turn ignition switch off. Doors will again lock, unlock to verify. Step 4 - BLAZER T-CASE SELF DIAGNOSTIC • Turn ignition switch 'ON' for at least 6 seconds. • Locate DLC (diagnostic connector) near right side of steering column. • Install jumper wire from pin #13 (orange wire, labels are small but they are on connector, use flashlight) to ground. • Turn the key on, engine off. Observe shift select buttons. If they all blink once at the same time there are no trouble codes. • Otherwise the light will blink (codes are 1-4 flashes) with a 3 second delay between codes if there are more than 1. • Run the codes if any are present repair as needed. Step 5 - HONDA SLIDING DOOR RE-HOME • Erase the sliding door trouble codes by removing the # 13 (7.5) fuse from the passenger's under-dash fuse box for 10 seconds. • Then put the fuse back in. • Turn off the main door switch; make sure that the ignition switch is off. • Manually open the sliding door and make sure it's fully open. • Turn the ignition switch on, then turn on the door switch. • Push and hold the CLOSE side of the dashboard door switch for that door until the door is fully closed. • Try the door operation with the dashboard door switch, the remote and the door handles. Helpful Information.
0 Comments
Leave a Reply. |